GOWN SIZES

All of our online  gowns listed online are made to order only, not made to measure. 

When the gown is purchased via our showroom appointments, we make our pieces as made-to-measure. You would be measured by one of our bridal stylists or the designer herself, and we would then make the gown to fit the best according to those measurements taken during the appointment.

We do offer in house alterations for brides that would like to fit their L’eto gown better closer to the wedding date for extra charge. We offer first alteration free of charge after the gown has been made and needs to be fitted after the fitting. All further alterations incur a charge of $420 AUD for each alteration.

Final adjustments with our alterations seamstress are the client’s responsibility after the gown has been collected from the store and/or shipped. We take no responsibility for alterations and changes made to our gowns after collection.

When the gown is purchased via one of our stockists, we make the pieces to order as per our size chart attached ( Imperial/inches or Metric/cm ). We would refer to AUS Size Small as Size 10, AUS Size Medium as Size 12, AUS Size Large as Size 14 etc.

We do not offer customisations of pieces purchased via our stockists.

Note: At the time of purchase via our stockists, we request your measurements in order to determine the size you require, and not to make the gown made to measure. If you are between sizes, we would always recommend going up a size to allow for optimum alterations afterwards.  

CUSTOM PIECES

Custom gown creation process is highly encouraged at L’eto. If the bride would like engage L’eto in creation of the custom dress, we require brides’ full set of measurements to be taken in store, which later is followed b a creation of a custom toile mock if required. After the fitting in store of the toile custom mock, we would discuss the changes made and then start making the custom dress itself. We allow only one mock fitting per process from the point of initial measurements taken in store and final gown unless otherwise specified by L’eto team at the time in the beginning of the process or once the production has started. Additional charges of $420 AUD per extra fitting will apply as we offer a limited number of fittings discussed with the client prior to the start of the production during the measurement fitting by L’eto staff member. All our custom designs start from $9000 AUD. We do not provide a gown sketch by the designer as part of our service.